T2F and T2B are the smallest cables in knitting. Two stitches swap places, and the pair leans one way or the other. They make neat little ropes between ribs, edging down a sweater front or a hat brim. This tutorial follows Joanne from King Cole Yarns, who works both twists on a light blue swatch, first without a cable needle and then with one.
How to knit T2F and T2B: the short version
- T2F (twist 2 front): knit the second stitch through the back loop, knit the first stitch, slip both off. The twist leans left.
- T2B (twist 2 back): knit the second stitch from the front, knit the first stitch, slip both off. The twist leans right.
- With a cable needle: slip 1 to the cable needle, hold it in front (T2F) or back (T2B), knit 1, then knit 1 from the cable needle.
- Purl the pair on the wrong side rows.
T2F, C2F and the names in your pattern
Pattern writers do not agree on names. Joanne calls these C2F and C2B (cable 2 front and back) and calls a twist T2. Other patterns use T2F and T2B, 1/1 LC and 1/1 RC, or C2L and C2R for the same moves. Some designers save T2F and T2B for a twist where a knit stitch crosses a purl stitch. That version uses the same moves, but you purl the stitch that ends up behind. Always check the abbreviation key at the front of the pattern before you start.
With or without a cable needle?
Both give the same look. Joanne notes the needle-free twist sits a fraction tighter, since one stitch is worked through the back loop. Pick one method and use it for the whole piece so every twist matches. Going without a needle is faster and handy for travel knitting, since there is nothing to drop. Reach for a cable needle with slippery yarn, very fine yarn, or if your hands find the needle-free reach awkward.
Yarn and needles to practice with
Use a smooth, light colored worsted or aran yarn and a needle size from the ball band. Light colors show how each stitch moves. Avoid fuzzy mohair or dark yarn until you can work the twist by feel. A short cable needle, or even a spare double pointed needle, holds the single stitch. Cast on about 20 stitches and work a pattern of purl 2, knit 2 across, so you get several pairs to practice on.
Common problems
- The twist leans the wrong way. You swapped front and back. Front leans left, back leans right.
- Loose or baggy twists. Snug the yarn after the second stitch, and keep the cable needle short.
- Dropped stitch. Do not slip the first stitch off until both stitches are knit.
- Lost your place. Twists usually repeat every 2 or 4 rows. Clip a marker on each twist row.
Where to go next
Once these feel easy, move up to four and six stitch ropes in how to knit cables. A gauge swatch tells you how much twists pull the fabric in, and reading a knitting pattern helps with abbreviations. Then add a twist column to a knitted hat.