How to Paint with a Palette Knife
Source: Jesse Robertson • Full tutorial: www.craftingstepbystep.com/painting/how-to-paint-with-a-palette-knife
- Difficulty
- Easy
- Hands-on time
- About 45 minutes
- Cost
- About $12 to $20
Tools
- Palette knife set
- Small detail palette knife
- Paper towels
Materials
- Heavy body acrylic paint
- Canvas board
- Stretched canvas
Steps
1. Use Heavy Body Paint
Reach for a heavy body acrylic rather than a fluid one. It holds its shape on the blade, which is the whole point of knife work.
Tip: Heavy body colours also settle into each other nicely, which matters for scumbling.

2. Pick Your Knife
Knives come with a bent shank or straight out from the handle. The bend keeps your hand up out of the wet paint and gives more dexterity.
Tip: Buy a set rather than a single knife. Different sizes suit different marks and sets are inexpensive.

3. Keep Paper Towel Beside You
Unlike a brush, a palette knife gets cleaned straight away and between every colour. Wipe the blade down on paper towel or an old rag as you go.

4. Load a Roll on the Edge
Cut a small roll of paint off the edge of the pile so it sits along the blade. Almost every technique that follows starts from this loaded edge, so it is worth getting a feel for how much paint to pick up.

5. Scumble for Broken Texture
Drag the loaded knife gently across the surface, letting the paint break rather than pressing it flat. You get a thick, rustic, patchy texture with whatever is underneath showing through.
Tip: The trick is not pushing too hard. Pressure flattens the mark and you lose the broken quality entirely.

6. Pull Straight Lines
Load paint right along the edge, hold the knife perpendicular to the surface and pull. You get a crisp straight line that is hard to achieve with a brush.
Tip: Expect to reload the edge for almost every line. One pull uses most of what is on the blade.

7. Carve Into Wet Paint
You can also work in reverse and carve lines out of paint that is already down. Use the tip to draw organic shapes like tree branches.

8. Build Impasto
Switch to a smaller knife for tight work, load the very tip and press the paint down rather than dragging it. Petals built this way stand right off the surface.
Tip: Some artists paint an entire canvas this way. It uses a lot of paint, so buy the big tubes.

9. Blend a Colour Gradient
Load two or more colours along the blade at once, then hold it at an angle and pull across the canvas. Swoop back over the join to blend it.
Tip: Clean the knife before you start the gradient or the previous colour muddies the blend.
