How to Make a Macrame Wreath (Easy Mandala Ring)
Source: Melanie Ham • Full tutorial: www.craftingstepbystep.com/macrame/how-to-make-a-macrame-wreath
- Difficulty
- Medium
- Hands-on time
- About 2 hours 30 minutes
- Cost
- About $8 to $18
- Makes
- 1 wreath
Tools
- sharp scissors
- fabric scissors
- tapestry needle
- pet slicker brush
- measuring tape
Materials
- 3-4mm twisted cotton macrame cord
- 10-inch metal ring
- wood beads
Steps
1. Gather the Macrame Cord, Metal Ring and Beads
Get out your twisted cotton cord, a 10 inch metal ring, ten wood beads, sharp scissors and a pet slicker brush. Cut the cord into 24 inch lengths.
Tip: Cut one cord, then use it as a measuring guide for the rest.

2. Tie Lark's Head Knots Onto the Macrame Wreath Ring
Fold a cord in half to make a loop. Lay the loop over the front of the ring, then bring the two tails down through it and pull snug.
Tip: Push each new knot tight against the last one so no ring shows between them.

3. Tie the First Row of Macrame Square Knots
Leave the two outer strands on each side alone for now. Take the middle four strands.
Tip: Always start the first half on the same side so every knot looks the same.

4. Add Offset Square Knots to Shape the Triangle
For the second row, take the right two strands from one knot and the left two from its neighbor, and tie a square knot between them. Do this in both gaps so the row has two knots sitting offset.
Tip: Pull each knot to the same tightness so the triangle stays even.

5. Tie Double Half Hitches Along the Triangle Edge
Bring in the outer strands you left aside. Take the far right strand as your lead cord and hold it at an angle along the edge of the triangle.
Tip: The angle you hold the lead cord at sets the curve, so hold it steady.

6. Work a Second Round of Half Hitches for the Border
Close the point where the two sides meet by tying one lead cord around the other. Then pick up the next strand as a new lead cord and run a second round of double half hitches down each side, tight under the first.
Tip: Working from the left can feel backward. Go slowly and check each wrap.

7. Add a Wood Bead Below the Macrame Unit
Thread one center lead cord through a tapestry needle and push it through the hole of a wood bead, then do the same with the other. Slide the bead up tight under the point of the unit.
Tip: Thread one cord at a time. Both at once is too bulky for the bead hole.

8. Unravel and Brush Out the Macrame Fringe
Cut all the strands at the bottom to about 3/4 inch with ordinary scissors. Then use the tapestry needle to pull apart the twists on each strand so the plies separate.
Tip: Hold the knots flat with your other hand while you brush so they stay neat.

9. Trim the Fringe and Repeat Around the Wreath Ring
Brushing makes the fringe a bit ragged, so trim it again with sharp fabric scissors for a crisp, even edge. Match the length to your other units.
Tip: Save your best fabric scissors for this final trim. Dull blades leave fuzzy ends.
