How to Fasten Off Crochet (the Beginner-Friendly Way)
Source: Knots & Kneedles • Full tutorial: www.craftingstepbystep.com/crochet/how-to-fasten-off-crochet
- Difficulty
- Easy
- Hands-on time
- About 10 minutes

Tools
- crochet hook
- blunt yarn needle / tapestry needle
- small scissors
Steps
1. Cut Your Yarn With a 4 to 6 Inch Tail
Finish your last stitch so you have one loop sitting on your hook. Then grab your scissors and snip the working yarn about four to six inches from that final loop.
Tip: Cut on the long side, not the short side. You can always trim a tail down later, but you cannot add length back once it is too short to thread a needle.

2. Yarn Over Your Hook With the Cut Tail
Slide your hook back into the loop you were working from and yarn over with the cut tail, exactly the way you would with the working yarn. The motion is identical to every yarn over you have done all the way through your project.
Tip: If the tail keeps slipping off the hook, pinch it against the hook with your thumb while you make the yarn over. Worsted yarn likes to skitter around.

3. Pull the Tail All the Way Through the Loop
Now pull the tail all the way through that last loop on your hook. This is different from a regular stitch where you stop with new loops on the hook.
Tip: You will see a little knot-like loop form at the top of your last stitch. That is what you want. It looks a bit lumpy until you weave the tail in, which flattens everything out.

4. Pull the Tail Tight to Secure
Give the tail a firm tug to snug the loop down against the rest of your work. The little knot you saw in step three should pull in close to the top of the stitch.
Tip: Do not pull so hard that the top of the work puckers. A firm tug is enough. If you see the fabric bunching, ease off and let the stitch sit naturally.

5. Thread the Tail Onto a Blunt Yarn Needle
Pick up a blunt-tip yarn needle with an eye big enough to hold your yarn. Rachel uses a plastic darning needle because the eye is wide and the tip will not split the plies as you weave.
Tip: Plastic yarn needles work great for worsted and bulky yarn because the eyes are huge. Metal tapestry needles are sharper and slide through tighter fabric more easily.

6. Weave the Tail In and Trim
Slide the needle through the body of several stitches in one direction, running it inside the fabric rather than across the front. Pull the yarn through gently, then go back the other way to lock the tail in place.
Tip: For amigurumi or any piece worked in the round, swap this last step for the invisible fasten off.
