Crafting Step by Step

How to Crochet a Coaster

Source: Bella Coco • Full tutorial: www.craftingstepbystep.com/crochet/how-to-crochet-a-coaster

Difficulty
Easy
Hands-on time
About 45 minutes
Cost
About $3 to $8
Makes
1 crochet coaster

Tools

  • 4mm or H/5mm crochet hook
  • Yarn needle
  • Scissors

Materials

  • Cotton DK yarn

Steps

  1. 1. Gather Your Yarn, Hook, and Notions

    Grab your yarn, a crochet hook, scissors, and a yarn needle. Bella uses Stylecraft Special DK with a 4mm hook.

    Tip: Cotton beats acrylic for coasters every time. Acrylic melts under a hot mug. Cotton just absorbs the condensation and dries out again.

  2. 2. Make a Slip Knot and Chain 6

    Start with a slip knot however you prefer, then slide it onto your hook. Wrap the yarn over the hook and pull it through the loop.

  3. 3. Join the Chain into a Ring

    Insert your hook into the very first chain you made (the one closest to the slip knot). Yarn over and pull through both loops on the hook.

    Tip: Prefer a tighter center? Use a magic ring instead. It closes flush instead of leaving the chain hole visible.

  4. 4. Round 1 - 19 Trebles into the Ring

    Chain 3 to count as your first treble (this is the UK treble, equivalent to a US double crochet ). Then work 19 more trebles directly into the center of the ring.

    Tip: UK treble crochet = US double crochet. If you're following a US pattern instead, watch for this - the same stitch name means a different stitch in each country.

  5. 5. Round 2 - Treble Pairs with Chain 2 Spaces

    Chain 3 to start the next round (counts as a treble). Work one more treble into the very next stitch.

  6. 6. Round 3 - Cluster of 4 in Each Chain Space

    Chain 3 to start. Skip the first stitch and work directly into the first chain 2 space from round 2.

    Tip: The chain 2 in the middle of each cluster is what creates the points of the flower in round 4. Keep your tension consistent or one point will pull tighter than the others.

  7. 7. Round 4 - Scalloped Edge with 6 Trebles per Space

    Chain 3, then slip stitch into the next chain 2 space to anchor the chain 3 down. Work 6 trebles into that same space - this is what creates the rounded scallop.

    Tip: If your scallops bunch up too tight, your trebles are pulling in. Loosen your tension on the yarn-over pulls so each treble has room to sit next to its neighbor.

  8. 8. Fasten Off and Weave in the Ends

    Yarn over one last time and pull through the loop on your hook to lock the final stitch. Snip the yarn about 6 inches from the work, then pull the tail all the way out.

    Tip: Weave each tail in two directions before snipping - up one row, then back across another. Single-direction weaving lets the tail pop back out after the first wash.

My notes

Scan for the full tutorial and video

Full tutorial with videos and details at www.craftingstepbystep.com/crochet/how-to-crochet-a-coaster