Crafting Step by Step

How to Crochet a Beanie (Beginner-Friendly Textured Hat)

Source: naztazia • Full tutorial: www.craftingstepbystep.com/crochet/how-to-crochet-a-beanie

Difficulty
Easy
Hands-on time
About 4 hours
Cost
About $8 to $15
Makes
1 beanie

Tools

  • size H 5mm crochet hook
  • scissors
  • yarn needle
  • stitch marker

Materials

  • worsted weight yarn (1 skein Red Heart Heat Wave or similar)
  • pompom (optional)

Steps

  1. 1. Chain 41 Loosely

    Grab one skein of worsted weight yarn (Donna uses Red Heart Heat Wave) and a size H 5mm hook. Make a slip knot, then chain 41 loosely.

    Tip: Count your chains twice before moving on. It's much easier to fix a miscount now than to discover it three rows in.

  2. 2. Work 12 Single Crochet and Place a Marker

    For Row 1, skip the first chain and work one sc into each of the next 12 chains. These 12 stitches become the ribbed brim and they stay sc the entire hat.

    Tip: Use a brightly colored stitch marker or a small safety pin so it pops against your yarn. Donna uses a green paperclip in the video.

  3. 3. Start the Crunch Stitch (hdc + sl st)

    Time for the crunch stitch, the textured top of the hat. In the next chain, work one hdc, then a sl st into the chain after that.

    Tip: Keep your slip stitches loose. Tight sl sts make the next row almost impossible to work into.

  4. 4. Row 2 - Crunch Stitch + Ribbing in Back Loops

    Row 2: ch 1, turn. You're now on the textured side again, so work the same crunch pattern across - hdc, sl st, hdc, sl st - stopping right before your stitch marker.

    Tip: The back loop is the loop farther from you when you look at the top of the stitch. Tilt the work toward you and you'll see two loops - go into the back one only.

  5. 5. Repeat Rows 2 and 3 Until You Hit 63 Rows

    Repeat Rows 2 and 3 over and over: one row of crunch stitch with sc ribbing on one side, then ch 1, turn, and do it again with the ribbing on the opposite side. Always work the 12 sc in back loops only and keep the ribbing stacked on the ribbing side.

    Tip: If your ribbed edge measures short, the hat won't stretch around your head. Switch to a larger hook and rip back rather than push through - you'll be happier with the fit.

  6. 6. Seam the Rectangle into a Tube

    Once you hit 63 rows, leave a long tail (at least 24 inches) for seaming. Fold the rectangle so Row 1 lines up with your last row, ribbing edge to ribbing edge.

    Tip: Use a blunt yarn needle (also called a tapestry needle) so you don't split the yarn fibers as you sew through them.

  7. 7. Cinch the Top and Attach a Pompom

    Cut a fresh 20-inch strand of yarn, double it for strength, and thread it onto your needle. Run the needle in and out along the top edge of the hat, then pull both ends to cinch the crown closed like a drawstring.

    Tip: Faux fur pompoms come with a built-in snap loop, which makes them easy to swap between hats if you want to wash one.

My notes

Scan for the full tutorial and video

Full tutorial with videos and details at www.craftingstepbystep.com/crochet/how-to-crochet-a-beanie