Crafting Step by Step

How to Change Colors in Crochet (Last Yarn-Over Method)

Source: Bella Coco • Full tutorial: www.craftingstepbystep.com/crochet/how-to-change-colors-in-crochet

Difficulty
Easy
Hands-on time
About 15 minutes

Tools

  • crochet hook (size 4mm or per your project)
  • scissors
  • yarn needle

Materials

  • main color yarn
  • contrast color yarn (any worsted or DK weight)

Steps

  1. 1. Stop at Two Loops on Your Last Stitch

    The whole technique rests on one rule: never finish the stitch in the old color. Work your last stitch until you have two loops left on the hook.

    Tip: This rule holds for every stitch: half treble, treble, double treble. Stop at two loops, no matter how tall the stitch is.

  2. 2. Loop the New Color Over and Pull Through

    With two loops left on the hook, drop the old strand and pick up the new color. Leave a three to four inch tail, fold the new yarn over the hook, and pull that loop through both loops on the hook to close the stitch.

    Tip: If you tie a knot here it will show as a bump on the right side of the work. Trust the yarn-over, it locks in cleanly.

  3. 3. Snip the Old Color and Settle the Tension

    Those first couple of stitches will look loose, and that's normal. Snip the old color leaving a matching three to four inch tail.

    Tip: If the stitches still look gappy after pulling the tails, give the whole row a light steam later. The fibers relax into place.

  4. 4. Chain One, Turn, and Lay the Tails Flat

    Chain one for your turning chain, then turn the work. Lay both tails flat along the top of the previous row so they sit between you and the working yarn.

    Tip: If your turning chain looks loose, that's the first stitch giving the tails a place to hide. It will tighten up once you've crocheted over them.

  5. 5. Crochet Over the Tails for an Inch or Two

    Insert your hook into the first stitch and work it normally, catching both loose tails inside the stitch alongside the top loops. Keep going stitch after stitch for at least an inch or two.

    Tip: If you can still feel the tail wiggle when you tug it, crochet over another inch before snipping. Better safe than a stripe that unravels in the wash.

  6. 6. Start a Mid-Row Change One Stitch Early

    Mid-row changes follow the same last-yarn-over rule, but timing matters. If the pattern wants the fifth stitch in a new color, you start the change on the fourth.

    Tip: Count out loud the first few times. It feels wrong to change on the stitch before the one you want, but that's exactly when the new color gets locked in.

  7. 7. Swap Back to the Original Color

    To swap back, treat the last stitch of the new-color block the same way: stop at two loops, drop the new color, and pick up the original strand you left hanging at the back. Yarn over with the old color, pull through both loops, and the next stitch picks up where you left off.

    Tip: For repeating stripes or colorwork, don't cut the yarn between blocks. Carry it loosely along the back and crochet over it on the next pass.

My notes

Scan for the full tutorial and video

Full tutorial with videos and details at www.craftingstepbystep.com/crochet/how-to-change-colors-in-crochet