How to Make a Mosaic Bird Bath
Source: Helen Miles Mosaics • Full tutorial: www.craftingstepbystep.com/crafts/how-to-make-a-mosaic-bird-bath
- Difficulty
- Easy
- Hands-on time
- About 1 hour
- Wait time
- 8 hours
- Cost
- About $15 to $25
- Makes
- 1 mosaic bird bath
Tools
- Old spoon or palette knife
- Yogurt pot for mixing
- Paintbrush
- Grout float or rubber spreader
- Sponge
- Rubber gloves
Materials
- Terracotta saucer rated for outdoor use
- Pre-cut 1cm and 2cm mosaic tiles
- Ceramic mosaic shapes
- Outdoor tile adhesive (thinset)
- PVA glue
- Mid-grey grout
Steps
1. Choose Your Saucer and Lay Out the Tiles
Start with a terracotta saucer from any garden centre. If you live somewhere that freezes, ask for one rated for outdoor use - an indoor saucer will crack over winter.
Tip: Broken plates work too, but that stops being a no-cut project - you would need to nip the pieces down first.

2. Seal the Saucer
Terracotta is thirsty. If you skip this, it pulls the water straight out of your adhesive and the bond suffers.
Tip: Use a pot you can throw away. Tile adhesive is cement-based and hardens, so it must never go near your drains.

3. Mix the Tile Adhesive
Any outdoor-rated tile adhesive will do. Brand matters far less than making sure the tub says it suits exterior use.

4. Set the Centre Motif
Butter the back of each piece with a little adhesive and press it into place. Helen builds a small flower in the middle from ready-made ceramic petals.
Tip: If adhesive squeezes up to the top of a piece, pick it off while it is still wet. Dried, it is a nuisance.

5. Work the Outer Rim
Jump out to the perimeter next rather than working straight out from the middle. Running the outer ring early gives you a clean, deliberate edge around the rim of the saucer.

6. Add a Ring of Larger Squares
Switch to the bigger 2cm squares for the next ring inward. The size contrast against the small pieces is what makes the bath look designed rather than random.

7. Fill the Centre
Fill what is left between the motif and the rings with lighter pieces. Keeping this band paler separates the three parts of the design so the flower still reads from a distance.

8. Grout the Mosaic
Mix up a mid-grey grout and work it across the whole surface, pushing it down into every gap between the tiles. Do the edges too, filling the gap between the outer tiles and the saucer rim.
Tip: Grout colour changes the whole look. Grey recedes and lets the tiles carry it; white brightens but shows dirt outdoors.

9. Rub It Back Clean
Give the grout a few minutes to firm up, then rub the surface back with a damp sponge until the tiles come up clean. Get the excess off the inner rim while it is still damp - it lifts easily now and fights you once it cures.
Tip: An ordinary kitchen cloth does the job as well as a proper grouting sponge.
