How to Make a Burlap Wreath (Pull-Through Method)
Source: This Southern Girl Can • Full tutorial: www.craftingstepbystep.com/crafts/how-to-make-a-burlap-wreath
- Difficulty
- Easy
- Hands-on time
- About 45 minutes
- Cost
- About $8 to $15
- Makes
- 1 wreath
Tools
- scissors
- wire cutters
Materials
- burlap ribbon roll, 5.5 inch wide
- wire wreath form, 12 to 18 inch
- thin green floral wire
Steps
1. Gather the Burlap Wreath Supplies
Set out a roll of burlap ribbon, a wire wreath form with four rings, a spool of thin floral wire, scissors and wire cutters. Amber picked up 5.5 inch wide burlap at Walmart, 30 feet for about three dollars and fifty cents.
Tip: Green floral wire disappears into the form, so it never shows on the finished wreath.

2. Fold the Burlap End and Thread the Floral Wire
Unroll some burlap. Fold the cut end in half lengthwise, then fold it in half again so you have a narrow, thick strip.
Tip: Leave a few inches of wire on each side so it is easy to twist.

3. Wire the Burlap End to the Wreath Form Crossbar
Lay the folded end on the form beside one of the crossbars, the short bars that join the four rings. Wrap the floral wire around the crossbar and twist it one or two times so the burlap is held tight.
Tip: Anchor the burlap on the back side of the crossbar so the wire hides under the ruffles.

4. Pull the First Burlap Loop Through the Inner Ring
Always work from the inside of the wreath out. Push the burlap down through the first section, the gap between the innermost two rings, and pull it back up to make a loop.
Tip: Keep the loops roughly the same height, but do not fuss over it.

5. Pull Burlap Loops Through the Middle and Outer Rings
Hold the first loop steady with one hand. With the other, feed the burlap through the second section, the middle gap, and pull up another loop about the same size.
Tip: Pull from underneath so each loop stands up straight.

6. Scrunch the Burlap Loop Bundle Together
Push the three loops over toward the anchored end so they bunch up into one tight bundle. That bundle is one ruffle.
Tip: Press the bundle down flat with your palm before the next step so it stays put.

7. Twist the Burlap to Lock the Bundle
Hold the bundle tight in one hand. With the other, twist the burlap ribbon over itself three times right where it leaves the bundle.
Tip: If a bundle feels loose later, give that twist one more turn.

8. Pull the Next Burlap Loop Through the Wreath Form
Still holding the twist, lay the burlap down and start the next bundle. Pull a loop through the inner section, then the middle, then the outer, the same way you did before.
Tip: Rough burlap grips itself, so tight bundles will not slide apart.

9. Spread and Fluff the Burlap Ruffles
As each section fills, spread the bundles out with your hands so the loops fan open and cover the wire. Keep working around the form, always inside to outside, pull, scrunch and twist, until the whole ring is full.
Tip: Fluff the loops toward the outside edge to hide the form from the side.

10. Fold the Burlap End to Tie Off the Wreath
When you reach the start, cut the burlap off the roll. Fold the end in half, then in half again, the same way you started.
Tip: Twist a loop of floral wire on the back of the top crossbar for hanging.
