How to Make a Father's Day Card with Bold Stencil Ink Blending
Source: Mindy Eggen Design • Full tutorial: www.craftingstepbystep.com/card-making/how-to-make-a-fathers-day-card
- Difficulty
- Medium
- Hands-on time
- About 35 minutes
- Cost
- About $15 to $30
- Makes
- 1 Father's Day ink blended card

Tools
- blender brushes
- glass media mat
- die cutting machine
- heat tool
- tweezers
- paper trimmer
- low-tack tape
Materials
- Sugar Cube card stock
- Sea Salt card stock
- black card stock
- Shattered stencil
- Lime Zest ink
- Cookie Monster ink
- Blue Corn ink
- white embossing powder
- embossing ink
- Dad die
- Dad Isms stamp set
- Sparkle Shimmer Spray
- foam tape
- Gina K Connect liquid glue
Steps
1. Tape the Stencil Over Your Card Panel
Trim Sugar Cube card stock to 4-1/4 by 5-1/2 inches. Lay the Shattered stencil over the card stock and tape the back with low-tack purple tape so the stencil can't shift while you blend.

2. Ink Blend Lime Zest at the Top
Load a Life Changing Blender brush with Lime Zest ink and work in small circles starting from the top edge of the stencil. Blend down about a third of the panel.

3. Blend the Middle Band with Cookie Monster
Switch to a fresh brush and load it with Cookie Monster blue. Start where the Lime Zest fades out and blend down through the middle third of the panel.

4. Blend Blue Corn at the Bottom
Take a third brush and load it with Blue Corn. Work from the bottom edge of the panel up into the Cookie Monster blue.

5. Spray Shimmer and Lift the Stencil
Mist a fine layer of sparkle shimmer spray across the panel from about a foot away. A few light passes is enough - heavy spray pools and warps the card stock.
Tip: If you don't have shimmer spray, water plus a few drops of Liquid Pearls in a spray bottle works the same way. Or skip it - the gradient stands on its own.

6. Die Cut and Stack the DAD Letters
Run the Dad die through your machine three times on Sugar Cube card stock. You'll have three identical sets of D-A-D letters.

7. Heat Emboss the Sentiment and Assemble
Stamp 'I love you. That is all.'
Tip: Use tweezers to position the small DAD letters - finger placement is messy with three-layer stacks of liquid glue.
